Page 1 of 1
Entangle spell not acting as ranged nor as area
Posted: Sat Apr 28, 2012 8:13 pm
by Zorinar
Entangle is listed as the following in our helpfiles:
Transmutation
Range: Ranged Area
Target: Noncombat
However, when I try to cast this without a target it only goes after the current single mob I am targetting, even if I am fighting a group.
Second, when I try to cast this spell in a direction, I get a fail.
Re: Entangle spell not acting as ranged nor as area
Posted: Sun May 06, 2012 2:52 am
by Raona
The entangle spell is currently missing an "area" flag. That seems to fix things up save that a save causes a "You were unable to find any valid targets for your 'entangle' spell." echo.
Canon has this as ranged, so I will set it as such for now, and see how that goes.
Re: Entangle spell not acting as ranged nor as area
Posted: Sun May 13, 2012 1:26 pm
by Zorinar
I tried entangle again today just to see if it is working for me after the changes.
It still is not acting as an area spell.
The mud is asking for a "target" when I type "c entangle."
Also trying to cast it as range with no target I get:
Sun flower seeds glows briefly.
A slim reed glows briefly.
You failed.
However, range single target castings do work now.
It does work when I cast it at a direct target in the same room however, it has never actually 'entanged' anything I have ever tried it on, including very small and very weak things. I am not sure if it is because I am only apprentice with it, or that the spell is really hard to get to stick, or the spell is not working, but I thought I would mention it.
Thanks.
Re: Entangle spell not acting as ranged nor as area
Posted: Tue Jun 19, 2012 11:25 am
by Raona
Actually, in my testing, the spell works at range, with or without a target, and does entangle things that fail a reflex save. But if every target saves, it gives the echo
You were unable to find any valid targets for your 'entangle' spell.
That does seem to be a bug.
I tried updating the helpfile to clarify...but will also ask others to reply here if they have had any trouble with this spell.
Re: Entangle spell not acting as ranged nor as area
Posted: Tue Jun 19, 2012 6:19 pm
by Althasizor
This echo actually isn't exclusive to entangle; For example, cast a Ranged Area spell such as chain lightning against m1708. If neither is affected, it gives the message that "You were unable to find any valid targets for your 'chain lightning' spell."
Code: Select all
You begin to chant.
A piece of fine silver wire glows briefly.
Some fur glows briefly.
A crystal rod glows briefly.
a drow invader seems to shake off the affects of the lightning.
a drow invader seems to shake off the affects of the lightning.
You were unable to find any valid targets for your 'chain lightning' spell.
This holds true of all or a lot of spells. Fireball, cone of cold, etc.
Re: Entangle spell not acting as ranged nor as area
Posted: Wed Jun 20, 2012 10:30 am
by Raona
Ah, good! So, in a nutshell, we have:
Observed:
Ranged spells return the echo
You were unable to find any valid targets for your 'XXX' spell.
when in fact they find valid target(s), but all the targets save against the spell.
Expected: A different echo, like
None of your targets succumbed to your 'XXX' spell.
is returned when they all make their saves or are otherwise unaffected.
Yes?